_ We are proud to offer complete and high quality Gunsmithing Service to private individuals and gun shops alike. Having the only Trade School trained gunsmith in Northeast Ohio, with over 30 years experience in all types of gun repair and refinishing, we are pleased to have a broad base of satisfied customers.

In the below listings you will find a cross-section of much of the work we do. If your specific need does not appear therein, please call or email and ask us about it.

_ Completely strip gun
Clean all parts
- Check for wear
- If called for, suggest any services needed to put in A-1 condition
Lubricate and reassemble

_ Bore Sight Customer’s Gun
Drill and Tap Barrel or Receiver for Sight
Cut Dovetail in Barrel
Install Insert in Pistol Sight
Install Front or Mid-Rib Bead on Shotgun
Install Receiver Sight
Scope Mounting

_ Long Forcing Cone
Re-solder Rib
Raising Dent in Barrel
Straighten/Adjust Barrel
Polish Chamber/Bore
Open/Modify Chock
Port Barrel
Refit Hinge-pin

Chamfer Revolver Barrel
Chamfer Revolver Cylinder
Revolver Action Job
Straighten Crane on Revolver
Remove/Modify Revolver Hammer Spur
Convert Revolver from Square Butt to
  Round Butt
Semi-Auto Pistol Action Job
Tighten Slide of 1911 Auto
Fit Barrel to 1911 Auto
Fit & Install Barrel Bushing on 1911
Bevel Mag. Well of 1911
Checker Front of Frame on 1911
Stipple Frame
Open & Modify Ejection Port of 1911 Slide
Throat, Polish Barrel & Feed Ramp of 1911
Fit new trigger to 1911
Fit Custom Hammer to 1911
Cut Slide for Dovetail Front Sight
Cut Slide for Novak Rear
Install Stake-on Front Sight
Modify 1911 Frame for Beavertail Safety
_

_ Check Headspace
Make Chamber Cast
Remove Stuck Fired Case from Chamber
Remove Live Round from Chamber
Remove Obstruction from Bore
Remove Fouling from Barrel
Reline .22 Rimfire Barrels
Cut and Crown Barrel
Chamber and Fit Barrel to Action
Install Pre-Threaded and Chambered Barrel
Thread Barrels; Mill Dovetails
Lap-In Bolt Lugs
Welding-On New Bolt Handle
Make and Install Spring
Parts Fabrication
Install Safeties
Triggers: Install and/or Adjust
Install Muzzle Brake
Install Barrel Band Swivel

_Hot Salt Bluing:
Factory Equivalent Finish:
- Disassemble
- Clean
- Strip
- #240 and #400 grit polish
- All screw holes and corners protected and square
- Bluing Process
- Oil and Reassemble
Master Finish:
- Same process as above plus:
- All polishing marks removed and no ripples
- Finished with #555, polish to a mirror finish
Rust Bluing
Parkerizing
- Zinc, gray
- Manganese, charcoal gray
Metal Checkering & Engraving
Engine Turning

_ Wood Finishing
- Hunter Finish
  - Unfilled Oil or Lacquer Finish
- Gunsmith Finish
  - Filled, Rubbed Oil Finish
Re-cut Checkering
Glass Bedding Barrel & Action
Install Recoil Pad
Install Adjustable Butt Plate
Install Sling Swivels
Install Stock Cross Bolt
Inletting and Finishing of Semi-Finished Stock
Fit, & Bed, Fiberglass Stock Blank

_ Pull Ball
Remove Broken Ramrod from Barrel